Logo Extrude not working for me

Everything Element 3D belongs here

Logo Extrude not working for me

Postby ozbum on 07/21/2012, 4:17 pm

The challenge I am having is adding the logo fill. The mask works fine, but when I use Diffuse to map the texture that is where I run into trouble. The fill does not line up & it has strange lines running thru the fill.
I have used an imported PNG & also tried making a comp with the logo fill & adding that to custom texture maps & I still get the same strange artifacts.
Anyone having success with extruding a logo that has a different fill/map than just a color or built in texture?
If so...how.

Thanks for any help you can provide.
ozbum
 
Posts: 3
Joined: 07/21/2012, 4:07 pm

Return to Element 3D