Help! Trying to make wormhole and doesn't work

Compositing and Motion Graphics

Help! Trying to make wormhole and doesn't work

Postby grandscheme on 11/15/2018, 1:38 am

We are trying to create a wormhole for short film based on this tutorial.
https://www.youtube.com/watch?v=6yr9yRivHo0

Everything is good. We create a donut in co pilot that uses a seamless texture. Then we create a camera. According to tutorial (around minute 6:45) we should just pull back AE camera and be inside donut and create wormhole effect POV .

But when we pull back we never get inside. It cuts off the inside. We see a full donut on the camera overhead so we have no idea why it's not working.
Screen Shot 2018-11-15 at 2.34.32 AM.png
Screen Shot 2018-11-15 at 2.34.32 AM.png (10.48 KiB) Viewed 621 times


Screen Shot 2018-11-15 at 2.34.08 AM.png


Screen Shot 2018-11-15 at 2.33.21 AM.png


Any one have any ideas?

Thanks.
grandscheme
 
Posts: 1
Joined: 11/15/2018, 1:23 am
System Specs: Imac
Element V2

Re: Help! Trying to make wormhole and doesn't work

Postby ender772 on 12/3/2018, 3:56 pm

did you ever figure it out. you probably need to do 1 of 2 things. either change your camera settings to be vey low mm..like 20. or in element 3d go down to render settings - camera cut off. its set to 10..change to 1. ohh...nevermind i just realized what the problem is...your donut is too small
ender772
 
Posts: 380
Joined: 04/19/2013, 3:52 pm


Return to After Effects