Help! Trying to make wormhole and doesn't work
2 posts • Page 1 of 1
Help! Trying to make wormhole and doesn't work
We are trying to create a wormhole for short film based on this tutorial.
https://www.youtube.com/watch?v=6yr9yRivHo0
Everything is good. We create a donut in co pilot that uses a seamless texture. Then we create a camera. According to tutorial (around minute 6:45) we should just pull back AE camera and be inside donut and create wormhole effect POV .
But when we pull back we never get inside. It cuts off the inside. We see a full donut on the camera overhead so we have no idea why it's not working.
Any one have any ideas?
Thanks.
https://www.youtube.com/watch?v=6yr9yRivHo0
Everything is good. We create a donut in co pilot that uses a seamless texture. Then we create a camera. According to tutorial (around minute 6:45) we should just pull back AE camera and be inside donut and create wormhole effect POV .
But when we pull back we never get inside. It cuts off the inside. We see a full donut on the camera overhead so we have no idea why it's not working.
Any one have any ideas?
Thanks.
- grandscheme
- Posts: 1
- Joined: 11/15/2018, 1:23 am
- System Specs: Imac
Element V2
Re: Help! Trying to make wormhole and doesn't work
did you ever figure it out. you probably need to do 1 of 2 things. either change your camera settings to be vey low mm..like 20. or in element 3d go down to render settings - camera cut off. its set to 10..change to 1. ohh...nevermind i just realized what the problem is...your donut is too small
- ender772
- Posts: 380
- Joined: 04/19/2013, 3:52 pm
2 posts • Page 1 of 1